TPS75201MPWPREP集成电路（IC）的线性+开关稳压器规格书PDF中文资料

TPS75201MPWPREP属于集成电路（IC）的线性+开关稳压器。由德州仪器制造生产的TPS75201MPWPREP稳压器 - 线性线性稳压器用于提供稳定的输出电压，无论负载电流、输入电压或环境因素如何变化，这些输出电压通常都要保持不变。它们的工作原理要求输入电压维持在高于所需的输出电压，而且要超出某个最小量，并且在工作时会将输入端的任何多余电压转换为热量。对于大多数应用而言，虽然这种稳压器的效率低于开关模式的稳压器，但它们通常更适合对噪声高度敏感的应用。

1FEATURES

2• Controlled Baseline

– One Assembly/Test Site, One Fabrication

Site

• Enhanced Diminishing Manufacturing Sources

(DMS) Support

• Enhanced Product-Change Notification

• Qualification Pedigree (1)

• 2-A Low-Dropout (LDO) Voltage Regulator

• Open-Drain Power-On Reset With 100-ms

Delay

• Ultralow 75-μA Typ Quiescent Current

• Fast Transient Response

• 2% Tolerance Over Specified Conditions for

Fixed-Output Versions

• 20-Pin TSSOP (PWP) PowerPAD™ Package

• Thermal Shutdown Protection

DESCRIPTION

The TPS75201M-EP is a low dropout regulator with an integrated power-on reset (RESET) function. This device

is capable of supplying 2 A of output current with a dropout of 210 mV. Quiescent current is 75 μA at full load

and drops down to 1 μA when the device is disabled. The TPS75201M-EP is designed to have fast transient

response for larger load current changes.

Because the PMOS device operates like a low-value resistor, the dropout voltage is very low (typically 210 mV at

an output current of 2 A) and is directly proportional to the output current. Additionally, since the PMOS pass

element is a voltage-driven device, the quiescent current is very low and independent of output loading (75 μA

typ over the full range of output current, 1 mA to 2 A). These two key specifications yield a significant

improvement in operating life for battery-powered systems.

The device is enabled when the enable (EN) input is connected to a low-level input voltage. This low-dropout

(LDO) device also features a sleep mode; applying a TTL high signal to EN shuts down the regulator, reducing

the quiescent current to 1 μA at TJ = 25°C.

The RESET (SVS, POR, or power-on reset) output of the TPS75201M-EP initiates a reset in microcomputer and

microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS75201M-EP

monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage.

When the output reaches 95% of its regulated voltage, RESET goes to a high-impedance state after a 100-ms

delay. RESET goes to a logic-low state when the regulated output voltage is pulled below 95% (i.e., overload

condition) of its regulated voltage.

The TPS75201M-EP is adjustable (programmable over the range of 1.5 V to 5 V). Output voltage tolerance is

specified as a maximum of 2% over line, load, and temperature ranges.