PIC32MM0016GPL036中文资料微芯科技数据手册PDF规格书

Microcontroller Features

•Low Pin Count Packages, Ranging from 20 to 36 Pins, including UQFN as Small as 4x4 mm

•Up to 64K Flash Memory:

-20,000 erase/write cycle endurance

-20 years minimum data retention

-Self-programmable under software control

•Up to 8K Data Memory

•Pin-Compatible with Most PIC24 MCU/dsPIC® DSC Devices

•Multiple Interrupt Vectors with Individually Programmable Priority

•Fail-Safe Clock Monitor mode

•Configurable Watchdog Timer with On-Chip, Low-Power RC Oscillator

•Programmable Code Protection

•Selectable Oscillator Options including:

-High-precision, 8 MHz internal Fast RC (FRC) oscillator

-High-speed crystal/resonator oscillator or external clock

-2x/3x/4x/6x/12x/24x PLL, which can be clocked from the FRC or primary oscillator

Peripheral Features

•Atomic Set, Clear and Invert Operation on Select Peripheral Registers

•High-Current Sink/Source 11 mA/16 mA on All Ports

•Independent, Low-Power 32 kHz Timer Oscillator

•Two 4-Wire SPI modules (up to 25 Mbps):

-16-byte FIFO

-I2S mode

•Two UARTs:

- RS-232, RS-485 and LIN/J2602 support

- IrDA® with on-chip hardware encoder and decoder

•External Edge and Level Change Interrupt on All Ports

•CRC module

•Hardware Real-Time Clock and Calendar (RTCC)

•Up to 20 Peripheral Pin Select (PPS) Remappable Pins

•Seven Total 16-Bit Timers:

-Timer1: Dedicated 16-bit timer/counter

-Two additional 16-bit timers in each MCCP and SCCP module

•Capture/Compare/PWM/Timer modules:

-Two 16-bit timers or one 32-bit timer in each module

-PWM resolution down to 21 ns

-One Multiple Output (MCCP) module:

-Flexible configuration as PWM, input capture, output compare or timers

-Six PWM outputs

-Programmable dead time

-Auto-shutdown

-Two Single Output (SCCP) modules:

-Flexible configuration as PWM, input capture, output compare or timers

-Single PWM output

•Reference Clock Output (REFO)

•Two Configurable Logic Cells (CLC) with Internal Connections to Select Peripherals and PPS

Debug Features

•Two Programming and Debugging Interfaces:

-2-wire ICSP™ interface with non-intrusive access and real-time data exchange with application

-4-wire MIPS® standard Enhanced JTAG interface

•IEEE Standard 1149.2 Compatible (JTAG) Boundary Scan

Analog Features

•Two Analog Comparators with Input

Multiplexing

•Programmable High/Low-Voltage

Detect (HLVD)

•5-Bit DAC with Output Pin

•Up to 14-Channel, Software-Selectable 10/12-Bit SAR Analog-to-Digital Converter (ADC):

-12-bit, 200K samples/second conversion rate (single Sample-and-Hold)

-10-bit, 300K samples/second conversion rate (single Sample-and-Hold)

-Sleep mode operation

-Band gap reference input feature

-Windowed threshold compare feature

-Auto-scan feature

•Brown-out Reset (BOR)