PCA9535HF

16-bit I2C-bus and SMBus, low power I/O port with interrupt

Generaldescription ThePCA9535andPCA9535Care24-pinCMOSdevicesthatprovide16bitsofGeneralPurposeparallelInput/Output(GPIO)expansionforI2C-bus/SMBusapplicationsandwasdevelopedtoenhancetheNXPSemiconductorsfamilyofI2C-busI/Oexpanders.Theimprovementsincludehigherd

ETC

PCA9535HF

16-bit I2C-bus and SMBus, low power I/O port with interrupt

Generaldescription ThePCA9535andPCA9535Care24-pinCMOSdevicesthatprovide16bitsofGeneral PurposeparallelInput/Output(GPIO)expansionforI2C-bus/SMBusapplicationsandwas developedtoenhancetheNXPSemiconductorsfamilyofI2C-busI/Oexpanders.The improvementsincludehighe

ETC

PCA9535HF

16-bit I2C-bus and SMBus, low power I/O port with interrupt; • Operating power supply voltage range of 2.3 V to 5.5 V\n• 5 V tolerant I/Os\n• Polarity Inversion register\n• Active LOW interrupt output\n• Low standby current\n• Noise filter on SCL/SDA inputs\n• No glitch on power-up\n• Internal power-on reset\n• 16 I/O pins which default to 16 inputs\n• 0 Hz to 400 kHz clock frequency\n• ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per JESD22-A115, and 1000 V CDM per JESD22-C101\n• Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA\n• Offered in four different packages: SO24, TSSOP24, HVQFN24 and HWQFN24\n;

The PCA9535 and PCA9535C are 24-pin CMOS devices that provide 16 bits of General Purpose parallel Input/Output (GPIO) expansion for I²C-bus/SMBus applications and was developed to enhance the NXP Semiconductors family of I²C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.\nThe PCA9535 and PCA9535C consist of two 8-bit Configuration (Input or Output selection), Input, Output and Polarity Inversion (active HIGH or active LOW operation) registers. The system master can enable the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data for each input or output is kept in the corresponding Input or Output register. The polarity of the read register can be inverted with the Polarity Inversion register. All registers can be read by the system master. Although pin-to-pin and I²C-bus address compatible with the PCF8575, software changes are required due to the enhancements and are discussed in Application Note AN469.\nThe PCA9535 is identical to the PCA9555 except for the removal of the internal I/O pull-up resistor which greatly reduces power consumption when the I/Os are held LOW.\nThe PCA9535C is identical to the PCA9535 except that all the I/O pins are high-impedance open-drain outputs.\nThe PCA9535 and PCA9535C open-drain interrupt output is activated when any input state differs from its corresponding Input Port register state and is used to indicate to the system master that an input state has changed. The power-on reset sets the registers to their default values and initializes the device state machine.\nThree hardware pins (A0, A1, A2) vary the fixed I2C-bus address and allow up to eight devices to share the same I2C-bus/SMBus. The fixed I2C-bus address of the PCA9535 and PCA9535C are the same as the PCA9555 allowing up to eight of these devices in any combination to share the same I2C-bus/SMBus.\n

恩XP

PCA9535PW

16-bitI2CandSMBus,lowpowerI/Oportwithinterrupt

DESCRIPTION ThePCA9535isa24-pinCMOSdevicethatprovide16bitsofGeneralPurposeparallelInput/Output(GPIO)expansionforI2C/SMBusapplicationsandwasdevelopedtoenhancethePhilipsfamilyofI2CI/Oexpanders.Theimprovementsincludehigherdrivecapability,5VI/Otolerance,lowe

PHI

PCA9535PW

REMOTE16-BITI2CANDSMBus,LOW-POWERI/OEXPANDERWITHINTERRUPTOUTPUTANDCONFIGURATIONREGISTERS