MSP430F1101AIDGVR.A中文资料德州仪器数据手册PDF规格书

Low Supply Voltage Range 1.8 V to 3.6 V

Ultralow Power Consumption

− Active Mode: 160 μA at 1 MHz, 2.2 V

− Standby Mode: 0.7 μA

− Off Mode (RAM Retention): 0.1 μA

Wake-Up From Standby Mode in

Less Than 6 μs

16-Bit RISC Architecture, 125 ns

Instruction Cycle Time

Basic Clock Module Configurations:

− Various Internal Resistors

− Single External Resistor

− 32-kHz Crystal

− High-Frequency Crystal

− Resonator

− External Clock Source

16-Bit Timer_A With Three

Capture/Compare Registers

On-Chip Comparator for Analog Signal

Compare Function or Slope

Analog-to-Digital (A/D) Conversion

Serial Onboard Programming,

No External Programming Voltage Needed,

Programmable Code Protection by

Security Fuse

Family Members Include

MSP430C1101: 1KB ROM, 128B RAM

MSP430C1111: 2KB ROM, 128B RAM

MSP430C1121: 4KB ROM, 256B RAM

MSP430F1101A: 1KB + 128B Flash Memory

128B RAM

MSP430F1111A: 2KB + 256B Flash Memory

128B RAM

MSP430F1121A: 4KB + 256B Flash Memory

256B RAM

Available in a 20-Pin Plastic Small-Outline

Wide Body (SOWB) Package, 20-Pin Plastic

Small-Outline Thin Package, 20-Pin TVSOP

(F11x1A only), and 24-Pin QFN

For Complete Module Descriptions, Refer

to the MSP430x1xx Family User’s Guide,

Literature Number SLAU049

description

The Texas Instruments MSP430 family of ultralow-power microcontrollers consists of several devices featuring

different sets of peripherals targeted for various applications. The architecture, combined with five low-power

modes is optimized to achieve extended battery life in portable measurement applications. The device features

a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code

efficiency. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less

than 6 μs.

The MSP430x11x1(A) series is an ultralow-power mixed signal microcontroller with a built-in 16-bit timer,

versatile analog comparator and fourteen I/O pins.

Typical applications include sensor systems that capture analog signals, convert them to digital values, and then

process the data for display or for transmission to a host system. Stand alone radio frequency (RF) sensor front

end is another area of application. The I/O port inputs provide single slope A/D conversion capability on resistive

sensors.