LP5522中文资料单通道可编程 LED 驱动器数据手册TI规格书

描述 Description

The LP5522 is a simple single wire programmable LED controller in six bump DSBGA package. It provides constant current flow through high side driver. Output current can be set from 1 mA to 20 mA by using an external resistor on the ISET pin. If no external resistor is used, output current is set to 5 mA default current. The LP5522 is controlled using only one signal. The signal controls either directly the LED driver or it launches previously programmed blinking sequence.
The LP5522 works autonomously without a clock signal from the master device. Very low LED driver headroom voltage makes possible to use supply voltages close to LED forward voltage. Current consumption of the LP5522 is minimized when LED is turned off and once controller is disabled all supporting functions are also shut down. Very small DSBGA package together with minimum number of external components is a best fit for handheld devices.

特性 Features

• Programmable Blinking Sequence
• 1 ms to 255 ms LED on Time
• Single or Continuous Run of Programmed Blinking Sequence
• Constant Current High Side Output Driver
• 0.2 µA Typical Shutdown Current
• DSBGA-6 Package with 0.4 mm Pitch:
- 1.215 mm x 0.815 mm x 0.6 mm (LxWxH)