LM75BIMM-3+传感器变送器的温度传感器-模拟数字输出规格书PDF中文资料

General Description

The LM75 temperature sensor includes a delta-sigma analog-to-digital converter, and a digital overtempera ture detector. The host can query the LM75 through its I2C interface to read temperature at any time. The open-drain overtemperature output (OS) sinks current when the programmable temperature limit is exceeded. The OS output operates in either of two modes, com parator or interrupt. The host controls the temperature at which the alarm is asserted (TOS) and the hysteresis temperature below which the alarm condition is not valid (THYST). Also, the LM75’s TOSand THYSTregis ters can be read by the host. The address of the LM75 is set with three pins to allow multiple devices to work

on the same bus. Power-up is in comparator mode, with defaults of TOS= +80°C and THYST= +75°C. The 3.0V to 5.5V supply voltage range, low supply current, and I2C interface make the LM75 ideal for many applications in thermal management and protection.

Features

♦ SO (SOP) and µMAX®(µSOP) Packages

♦ I2C Bus Interface

♦ Separate Open-Drain OS Output Operates as

   Interrupt or Comparator/Thermostat Input

♦ Register Readback Capability

♦ Power-Up Defaults Permit Stand-Alone Operation as a Thermostat

♦ 3.0V to 5.5V Supply Voltage

♦ Low Operating Supply Current 250µA (typ), 1mA(max)

♦ 4µA (typ) Shutdown Mode Minimizes Power Consumption

♦ Up to Eight LM75s Can Be Connected to a Single Bus

♦ Pin- and/or Register-Compatible with Improved Performance Maxim Sensors Including

   MAX7500, MAX6625, MAX6626, DS75LV, and DS7505

Applications

   Thermal System Management

   Thermal Protection

   Test Equipment

   Computers and Office Electronics