General Description

The IXDD408 is a high speed high current gate driver specifically designed to drive the largest MOSFETs and IGBTs to their minimum switching time and maximum practical frequency limits. The IXDD480 can source and sink 8A of peak current while producing voltage rise and fall times of less than 30ns. The input of the driver is compatible with TTL or CMOS and is fully immune to latch up over the entire operating range. Designed with small internal delays, cross conduction/current shoot through is virtually eliminated in the IXDD408. Its features and wide safety margin in operating voltage and power make the IXDD408 unmatched in performance and value.

The IXDD408 incorporates a unique ability to disable the output under fault conditions. When a logical low is forced into the Enable input, both final output stage MOSFETs (NMOS and PMOS) are turned off. As a result, the output of the IXDD408 enters a tristate mode and achieves a Soft Turn-Off of the MOSFET/IGBT when a short circuit is detected. This helps prevent damage that could occur to the MOSFET/IGBT if it were to be switched off abruptly due to a dv/dt over-voltage transient.

The IXDD408 is available in the standard 8-pin P-DIP (PI), SOP-8 (SI), 5-pin TO-220 (CI) and in the TO-263 (YI) surface-mount package.

Features

• Built using the advantages and compatibility of CMOS and IXYS HDMOSTM processes.

• Latch Up Protected

• High Peak Output Current: 8A Peak

• Operates from 4.5V to 25V

• Ability to Disable Output under Faults

• High Capacitive Load

Drive Capability: 2500pF in <15ns

• Matched Rise And Fall Times

• Low Propagation Delay Time

• Low Output Impedance

• Low Supply Current

Applications

• Driving MOSFETs and IGBTs

• Limiting di/dt under Short Circuit

• Motor Controls

• Line Drivers

• Pulse Generators

• Local Power ON/OFF Switch

• Switch Mode Power Supplies (SMPS)

• DC to DC Converters

• Pulse Transformer Driver

• Class D Switching Amplifiers

IXDD408PI属于集成电路（IC） > 栅极驱动器。IXYS Integrated Circuits Division制造生产的IXDD408PI栅极驱动器栅极驱动器电源管理集成电路 (PMIC) 可用于提供隔离、放大、参考位移、自举或其他必要功能，这些功能可将来自电源转换应用中控制设备的信号连接到电源被控制通过的半导体设备（通常为 FET 或 IGBT）。任何特定设备提供的确切功能各不相同，但与它适合驱动的半导体配置相关。