8-bit 8-channel D/A converter

IT88347 is a 8 Channels R2R CMOS Digital to Analog Converter (DAC) with 8-bit resolution, low leakage current and low operating current. The IT88347 has built in operational amplifier output buffers which canoperate in full-swing voltage range from GND to VCC (3.0V to 5.5V) with the Drive/Sink curre Wide Operation Power Supply range from 3.0V to 5.5V without sacrificing performance\nHigh Linearity Resolution DNL < +- 0.5LSB; INL <= +-0.6LSB\n12 bits serial data input controlled by 3 wire serial data transfer pins DI, CLK, LD \nMax. 2.5MHz serial digital data input \nSerial I/O data for cascade ;

Innochip

世纪创新

R-2R TYPE 8-BIT D/A CONVERTER WITH OPERATIONAL AMPLIFIER OUTPUT BUFFERS

■DESCRIPTION The MB88347 features 8 channels of 8-bit D/A converters (with output amplifiers). The output amplifier provides high current drive capability. As data is input via a seriallink, only three control lines are required, and cascaded connections can be used. The MB88347 is suitable for

文件：190.74 Kbytes 页数：20 Pages

Fujitsu

富士通

D/A Converter for Digital Tuning (8-channel, 8-bit, on-chip OP amp, low-voltage)

■ DESCRIPTION The MB88347L incorporates eight 8-bit D/A converter modules. This device operates at low supply voltage in the performance guarantee range from 2.7 to 3.6 V. It also contains an output amplifier, allowing driving at large current. Since the MB88347L inputs data in serial mode, it r

文件：169.85 Kbytes 页数：16 Pages

Fujitsu

富士通

D/A Converter for Digital Tuning (8-channel, 8-bit, on-chip OP amp, low-voltage)

■ DESCRIPTION The MB88347L incorporates eight 8-bit D/A converter modules. This device operates at low supply voltage in the performance guarantee range from 2.7 to 3.6 V. It also contains an output amplifier, allowing driving at large current. Since the MB88347L inputs data in serial mode, it r

文件：169.85 Kbytes 页数：16 Pages

Fujitsu

富士通