ADM1022集成电路（IC）的传感器检测器接口规格书PDF中文资料

GENERAL DESCRIPTION

The ADM1022 is a low cost temperature monitor and fan controller for microprocessor-based systems. The temperature of one or two remote sensor diodes may be measured, allowing monitoring of processor temperature in single- or dual-processor systems.

Measured values can be read out via a serial System Management Bus, and values for limit comparisons can be programmed in over the same serial bus.

The ADM1022 also contains a DAC for fan speed control. Automatic hardware temperature trip points are provided and the fan will be driven to full speed if they are exceeded.

Finally, the chip has two supply voltage monitors for brownout detection.

The ADM1022’s 3.0 V to 5.5 V supply voltage range, low supply current, and SMBus interface make it ideal for a wide range of applications. These include hardware monitoring and protection applications in personal computers, electronic test equipment and office electronics.

FEATURES

External Temperature Measurement with Remote

Diode (Two Channels)

On-Chip Temperature Sensor

Interrupt and Over-Temperature Outputs

Fault Tolerant Fan Control

Brownout Detection

LDCM Support

System Management Bus (SMBus)

Standby Mode to Minimize Power Consumption

Limit Comparison of all Monitored Values

APPLICATIONS

Network Servers and Personal Computers

Microprocessor-Based Office Equipment

Test Equipment and Measuring Instruments