10 關A, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifier

GENERAL DESCRIPTION The AD8546 and AD8548 are dual and quad micropower, high input impedance amplifiers optimized for low power and wide operating supply voltage range applications. The AD8546/AD8548 rail-to-rail input/output (RRIO) feature provides increased dynamic range to drive low frequ

文件：708.92 Kbytes 页数：20 Pages

AD

亚德诺

10 關A, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

GENERAL DESCRIPTION The AD8546 and AD8548 are dual and quad micropower, high input impedance amplifiers optimized for low power and wide operating supply voltage range applications. The AD8546/AD8548 rail-to-rail input/output (RRIO) feature provides increased dynamic range to drive low frequ

文件：825.94 Kbytes 页数：20 Pages

AD

亚德诺

22 μA, RRIO, CMOS, 18 V Operational Amplifier

FEATURES Micropower at high voltage (18 V): 22 μA maximum Low input bias current: 20 pA maximum Gain bandwidth product: 240 kHz at AV =100 typical Unity-gain crossover: 240 kHz −3 dB closed-loop bandwidth: 310 kHz Slew rate: 80 V/ms Large signal voltage gain: 110 dB minimum Single-supply operat

文件：709.49 Kbytes 页数：24 Pages

AD

亚德诺

Micropower Precision CMOS Operational Amplifier

FEATURES Supply current: 1 μA maximum Offset voltage: 1 mV maximum Single-supply or dual-supply operation Rail-to-rail input and output No phase reversal Unity gain stable APPLICATIONS Portable equipment Remote sensors Low power filters Threshold detectors Current sensing

文件：456.87 Kbytes 页数：12 Pages

AD

亚德诺

1 μA Micropower CMOS Operational Amplifiers

FEATURES Supply current: 1 μA maximum/amplifier Offset voltage: 3 mV maximum Single-supply or dual-supply operation Rail-to-rail input and output No phase reversal Unity gain stable APPLICATIONS Portable equipment Remote sensors Low power filters Threshold detectors Current sensing

文件：518.52 Kbytes 页数：16 Pages

AD

亚德诺

10 μA, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

FEATURES PSRR: 100 dB minimum CMRR: 105 dB typical Very low supply current: 10 μA per amplifier maximum 1.8 V to 5 V single-supply or ±0.9 V to ±2.5 V dual-supply operation Rail-to-rail input and output 3 mV offset voltage maximum Very low input bias current: 0.5 pA typical APPLICATIONS Pres

文件：856.06 Kbytes 页数：24 Pages

AD

亚德诺

10 關A, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifiers

文件：846.26 Kbytes 页数：24 Pages

AD

亚德诺

22 關A, RRIO, CMOS, 18 V

文件：696.47 Kbytes 页数：24 Pages

AD

亚德诺

10 UA, Rail-to-Rail I/O, Zero InputCrossover Distortion Amplifiers

文件：846.26 Kbytes 页数：24 Pages

AD

亚德诺

双通道10 μA，轨对轨I/O，零输入，交越失真放大器

ADA4505-2是一款双通道微功耗放大器，具有轨对轨输入与输出摆幅，采用1.8 V～5 V单电源或±0.9 V～±2.5 V双电源供电。这款低成本放大器采用新式的电路技术，具有零输入交越失真（出众的PSRR与CMRR性能）以及极低的偏置电流，工作时每个放大器的电源电流不到10μA。这些特性的结合使得ADA4505-2放大器成为电池供电应用的理想选择，因为它可以使得整个电池寿命周期内因电源电压波动而引起的误差较小，而且即使对于轨对轨输入运算放大器也能保持较高的共模抑制比。 ADA4505-2放大器非常适合于电池供电的遥控传感器、手持仪器以及消费类设备、危险探测（例如，烟、火与气体）以 • 特性 PSRR：100 dB（最小值）\n\n• CMRR：105 dB（典型值）\n\n• 极低的电源电流：每个放大器为10 μA（最大值）\n\n• 单电源电压：1.8 V～5 V或双电源电压：±0.9 V～±2.5 V \n\n• 轨对轨输入与输出\n\n• 失调电压：2.5 mV（最大值）\n\n• 极低的输入偏置电流：0.5 pA（典型值）;

ADI

亚德诺