Features

 STMicroelectronics positioning receiver with 48

tracking channels and 2 fast acquisition

channels supporting GPS, Galileo, GLONASS,

BeiDou and QZSS systems

 Single die standalone receiver embedding RF

Front-End and low noise amplifier

 -162 dBm indoor sensitivity (tracking mode)

 Fast TTFF < 1 s in Hot start and 30 s in Cold

Start

 High performance ARM946 MCU (up to

196 MHz)

 256 Kbyte embedded SRAM

 In-Package SQI Flash Memory (16 or 32 Mbits)

 Real Time Clock (RTC) circuit

 32-bit Watch-dog timer

 3 UARTs

 1 I2C master interface

 1 Synchronous Serial Port (SSP, Motorola-SPI

supported)

 USB2.0 full speed (12 MHz) with integrated

physical layer transceiver

 2 Controller Area Network (CAN)

 2 channels ADC (10 bits)

 1 Secure-Digital Multimedia Memory Card

Interfaces (SDMMC)

 1 Multichannel Serial Port (MSP)

 Power Management Unit (PMU) embedding

switching regulator

 Operating condition:

– Main voltage regulator (VINL): 1.6V to 4.3V

– Backup voltage (VINB): 1.6V to 4.3V

– Digital voltage (VDD): 1.0 V to 1.32 V

– RF core voltage (VCC): 1.2 V ± 10

– IO Ring Voltage (VddIO): 1.8 V ± 5 or

3.3 V ± 10

 Package:

– TFBGA99 (5 x 6 x 1.2 mm) 0.5 mm pitch

 Operating temperature range: -40/+85°C

Description

STA8090FG belongs to Teseo III family products. STA8090FG is a single die standalone positioning receiver IC working on multiple constellations (GPS/Galileo/GLONASS/BeiDou/QZSS).

STA8090FG, thanks to the ARM9 and wide IOs availability, can be used as microcontroller with GNSS capability, allowing a very compact design offering 256 kByte of internal RAM and 16 Mbits or 32 Mbits of internal Flash.

The minimal BOM makes STA8090FG the ideal solution for cost competitive and small footprint products such as OBD dongle, insurance boxes, trackers, telematics, portable, hands-held portable and sports accessories.

STA8090FGBD can also run TESEO-DRAW the STMicroelectronics dead reckoning firmware.

STA8090FG属于RF/IF，射频/中频和 RFID > 射频接收器。意法半导体（ST）集团制造生产的STA8090FG射频接收器RF 接收器用于接收已调制的射频信号并对其进行解调，然后将数据传送到系统中进行处理。频率范围是 AM、FM、WB、0 Hz 至 64 GHz，数据速率为 250 bps 至 16 Gbps，数据接口包括连接器、I2C、I2S、引脚焊盘、并行、PCB、串行、焊盘、SPI、UART 和 USB。