General description

The PCA9508 is a CMOS integrated circuit that supports hot-swap with zero offset and provides level shifting between low voltage (down to 0.9 V) and higher voltage (2.7 V to 5.5 V) for I2C-bus or SMBus applications. While retaining all the operating modes and features of the I2C-bus system during the level shifts, it also permits extension of the I2C-bus by providing bidirectional buffering for both the data (SDA) and the clock (SCL) lines, thus enabling two buses of 400 pF. Using the PCA9508 enables the system designer to isolate two halves of a bus for both voltage and capacitance, and perform hot-swap and voltage level translation. Furthermore, the dual supply pins can be powered up in any sequence; when any of the supply pins are unpowered, the 5 V tolerant I/O are high-impedance.

Features

■ 2 channel, bidirectional buffer isolates capacitance and allows 400 pF on either side of the device

■ Supports offset-free hot-swap with IDLE/STOP detect circuitry

■ Voltage level translation from 0.9 V to 5.5 V and from 2.7 V to 5.5 V

■ Footprint and functional replacement for PCA9515, PCA9515A, PCA9517 and PCA9517A

■ I2C-bus and SMBus compatible

■ Active HIGH repeater enable input

■ Static level offset on B side

■ Open-drain input/outputs

■ Lock-up free operation

■ Supports arbitration and clock stretching across the repeater

■ Accommodates Standard-mode and Fast-mode I2C-bus devices and multiple masters

■ Powered-off high-impedance I2C-bus pins

■ A side operating supply voltage range of 0.9 V to 5.5 V

■ B side operating supply voltage range of 2.7 V to 5.5 V

■ 5 V tolerant I2C-bus and enable pins

■ 0 Hz to 400 kHz clock frequency (the maximum system operating frequency may be less than 400 kHz because of the delays added by the repeater).

■ ESD protection exceeds 6000 V HBM per JESD22-A114, 450 V MM per JESD22-A115, and 1000 V CDM per JESD22-C101

■ Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA

■ Packages offered: SO8 and TSSOP8

PCA9508D属于集成电路（IC） > 信号缓冲器、中继器、分离器。恩智浦半导体公司制造生产的PCA9508D信号缓冲器、中继器、分离器信号缓冲器、中继器和分离器系列中的产品适用于远距离电气互连或电缆系统的数字信息传输。所有实际互连系统都具有非理想特性，该系列产品主要用于解决数字信息传输过程中因此造成的模拟问题。此外，还有其他功能，例如不同物理接口样式之间的转换和多路复用。