General description

The NVT4556 device is built for interfacing a SIM card with a single low-voltage host-side

interface. The NVT4556 contains an LDO that can deliver two different voltages, 1.8 V or

3 V, from a typical mobile phone battery voltage, and three level translators to convert the

data, RSTn and CLKn signals between a SIM card and a host microcontroller.

The NVT4556 VCC pin provides power to the host side I/Os and doubles as an enable pin,

for this reason it can be connected to a GPIO that matches the host side voltage. The total

current draw from the VCC pin is only 100 A maximum. The NVT4556 also uses the

I2C-bus interface to enable normal operation and to select either 1.8 V or 3 V for the SIM

card power supply. The NVT4556 can also disable the LDO functionality while maintaining

the level translator paths so that the user can use a system-controlled regulator to power

the SIM card power supply. The NVT4556 can enable users to provide second and third

SIM card functionality with a low-voltage one host SIM port, at the same time reducing the

number of GPIOs used in the system. The NVT4556 is compliant with all ETSI, IMT-2000

and ISO-7816 SIM/Smart card interface requirements.

The NVT4556 is available in a 12-pin WLCSP package and has three factory

programmed slave address options.

Features and benefits

 Support SIM card supply voltages 1.8 V and 3 V

 Input voltage range to LDO: 2.5 V to 5.25 V

 Host microcontroller operating voltage range: 1.55 V to 3.6 V

 VCC input pin provides both host supply voltage and logic level hardware

enable/disable pin: source through Host GPIO (ICC <100 A)

 RST_HOST/EN pin can be programmed as a reset pin or as a device enable/disable

pin

 Level translation of I/O, RSTn and CLKn between SIM card and host-side interface

with capacitive isolation

 I2C-bus interface for device enable and LDO voltage selection

 Low current shutdown mode < 3 A

 Supports clock speed beyond 5 MHz clock

 Supports CLK stop mode

 Integrated EMI filters

 Incorporates ISO-7816-3 shutdown feature for the SIM card signals

 ETSI, IMT2000 and ISO-7816 compliant

 8 kV IEC61000-4-2 ESD protected on all SIM card contact pins

 Pb-free, Restriction of Hazardous Substances (RoHS) compliant and free of halogen

and antimony (Dark Green compliant)

 Available in 12-pin WLCSP package (1.205 mm  1.605 mm  0.412 mm,

0.4 mm pitch)

Applications

 NVT4556 can be used with a range of SIM card attached devices including:

 Mobile and personal phones

 Wireless modems

 SIM card terminals

NVT4556属于集成电路（IC） > 专用。恩智浦半导体公司制造生产的NVT4556专用该系列产品可提供所需的功能，用以将信息源/信宿连到各种复杂或范围狭窄应用中的传感器、变送器、致动器、传输介质或其他此类端点。例如，汽车安全气囊驱动器、车身控制和信息娱乐总线、自适应电缆均衡器、智能卡等等。