Description

The MT9074 is a single chip device, operable in either T1 or E1 mode, integrating either an advanced T1 (T1 mode) or PCM 30 (E1 mode) framer with a Line Interface Unit (LIU).

Features

• Combined E1 (PCM 30) and T1 (D4/ESF) framer, Line Interface Unit (LIU) and link controller with optional digital framer only mode

• In T1 mode the LIU can recover signals attenuated by up to 36 dB (6000 ft. of 24 AWG cable)

• In E1 mode the LIU can recover signals attenuated by up to 36 dB (2000 m. of 0.65mm cable)

• Two HDLCs: FDL and channel 24 in T1 mode, timeslot 0 (Sa bits) and timeslot 16 in E1 mode

• Two-frame elastic buffer in Rx & Tx (T1) directions

• Programmable transmit delay through transmit slip buffer

• Low jitter DPLL for clock generation

• Enhanced alarms, performance monitoring and error insertion functions

• Intel or Motorola non-multiplexed parallel microprocessor interface

• ST-BUS 2.048 Mbit/s backplane bus for both data and signaling

• Japan Telecom J1 Framing and Yellow Alarm

• Hardware data link access

• JTAG Boundary Scan

Applications

• E1/T1 add/drop multiplexers and channel banks

• CO and PBX equipment interfaces

• Primary Rate ISDN nodes

• Digital Cross-connect Systems (DCS)