首页>ADUM4137WBRNZ-RL>规格书详情
ADUM4137WBRNZ-RL中文资料PDF规格书
ADUM4137WBRNZ-RL规格书详情
GENERAL DESCRIPTION
The ADuM41371 is a single-channel gate driver specifically optimized for driving insulated gate bipolar transistors (IGBTs). Analog Devices, Inc., iCoupler® technology provides isolation between the input signal and the output gate drive.
The Analog Devices chip scale transformers also provide isolated communication of control information between the high voltage and low voltage domains of the chip. Information on the status of the chip can be read back from the dedicated fault outputs. The ADuM4137 provides isolated fault reporting for overcurrent events, remote temperature overheating events, undervoltage lockout (UVLO), and thermal shutdown (TSD). Integrated onto the ADuM4137 is an overcurrent detection feature that protects the IGBT in case of overcurrent events. The split emitter overcurrent detection is coupled with a high speed, two-level turn off in case of faults.
The ADuM4137 provides a Miller clamp control signal for the external metal-oxide semiconductor field effect transistor (MOSFET) to provide robust IGBT turn off with a single rail supply when the gate voltage drops below 2.0 V (typical) and above GND2. Operation with unipolar secondary supplies is possible, with or without the Miller clamp operation.
A low gate voltage detection circuit can trigger a fault if the gate voltage does not go above the internal threshold (VVL) within the time allowed from turn on (tDVL). This circuit allows detection of IGBT device failures that exhibit gate shorts or other causes of weak drive.
The secondary falling UVLO is set to 11.24 V (typical) for common IGBT two-level plateau voltage levels.
The ADuM4137 provides for in field programming of temperature. Two temperature sensor pins allow isolated monitoring of system temperatures at the IGBTs, sensing diode gains and offsets by means of a serial port interface (SPI) bus on the primary side of the device. Values are stored on an EEPROM located on the secondary side. Additionally, programming is available for specific voltage offsets, temperature sensing reporting frequencies, and important delays.
The ASC pin on the secondary side on the ADuM4137 allows the driver to be switched on from the secondary side if no faults are present.
FEATURES
6 A peak drive output capability
Internal turn off NFET, on resistance: <0.95 Ω
Internal turn on PFET, on resistance: <1.18 Ω
Split emitter overcurrent detection
Miller clamp output with gate sense input
Isolated fault output
Isolated temperature sensor read back
Propagation delay
Rising: 105 ns typical
Falling: 107 ns typical
Minimum pulse width: 70 ns
Operating junction temperature range (−40°C to +150°C)
VDD1 and VDD2 UVLO
ASC input
8.3 mm creepage distance
Safety and regulatory approvals
5 kV rms for 1 minute per UL 1577
CSA Component Acceptance Notice 5A
DIN V VDE V 0884-10 (VDE V 0884-10):2006-12
VIORM = 849 VPEAK (reinforced/basic)
AEC-Q100 qualified for automotive applications
供应商 | 型号 | 品牌 | 批号 | 封装 | 库存 | 备注 | 价格 |
---|---|---|---|---|---|---|---|
ADI(亚德诺) |
23+ |
SOP-28-300mil |
5768 |
百分百原装正品,可原型号开票 |
询价 | ||
ADI |
21+ |
N/A |
6000 |
询价 | |||
ADI(亚德诺)/LINEAR(凌特) |
23+ |
SOIC28300mil |
6000 |
诚信服务,绝对原装原盘 |
询价 | ||
ADI/亚德诺 |
21+ |
原封装 |
13880 |
公司只售原装,支持实单 |
询价 | ||
ADI |
23+ |
20000 |
全新、原装、现货 |
询价 | |||
ADI/亚德诺 |
24+ |
SOIC-28 |
860000 |
明嘉莱只做原装正品现货 |
询价 | ||
ADI(亚德诺)/LINEAR |
1921+ |
SOIC-28 |
3575 |
向鸿仓库现货,优势绝对的原装! |
询价 | ||
ADI(亚德诺) |
23+ |
N/A |
10000 |
正规渠道,只有原装! |
询价 | ||
ADI(亚德诺) |
23+ |
N/A |
589610 |
新到现货 原厂一手货源 价格秒杀代理! |
询价 | ||
ADI-亚德诺 |
24+25+/26+27+ |
SOIC-28 |
6328 |
一一有问必回一特殊渠道一有长期订货一备货HK仓库 |
询价 |