GENERAL DESCRIPTION

The ADG3304 is a bidirectional logic level translator that con-tains four bidirectional channels. It can be used in multivoltage digital system applications, such as data transfer, between a low voltage digital signal processing controller and a higher voltage device using SPI and MICROWIRE interfaces. The internal architecture allows the device to perform bidirectional logic level translation without an additional signal to set the direction in which the translation takes place.

The voltage applied to VCCA sets the logic levels on the A side of the device, while VCCY sets the levels on the Y side. For proper operation, VCCA must always be less than VCCY. The VCCA-com-patible logic signals applied to the A side of the device appear as VCCY-compatible levels on the Y side. Similarly, VCCY-compatible logic levels applied to the Y side of the device appear as VCCA-compatible logic levels on the A side.

The enable pin (EN) provides three-state operation on both the A side and the Y side pins. When the EN pin is pulled low, the terminals on both sides of the device are in the high impedance state. The EN pin is referred to the VCCA supply voltage and driven high for normal operation.

The ADG3304 is available in compact 14-lead TSSOP, 12-ball WLCSP, and 20-lead LFCSP. It is guaranteed to operate over the 1.15 V to 5.5 V supply voltage range.

FEATURES

Bidirectional level translation

Operates from 1.15 V to 5.5 V

Low quiescent current < 5 μA

No direction pin

Qualified for automotive applications

APPLICATIONS

SPI, MICROWIRE level translation

Low voltage ASIC level translation

Smart card readers

Cell phones and cell phone cradles

Portable communications devices

Telecommunications equipment

Network switches and routers

Storage systems (SAN/NAS)

Computing/server applications

GPS

Portable POS systems

Low cost serial interfaces

ADG3304BCBZ-REEL属于集成电路（IC） > 转换器，电平移位器。亚德诺半导体技术有限公司制造生产的ADG3304BCBZ-REEL转换器，电平移位器逻辑转换器或电平移位器 IC 可用于在数字逻辑设备之间传递信息，这些设备可在不同/不兼容的供电电压下工作，或可实现不同的信令方式。例如，可以将需要 5 V 电源的数字输出传感器连接到具有 3.3 V I/O 电源的 FPGA，或者在 CMOS 或 TTL 等单端信令方式与 PECL 或 LVDS 等差分技术之间进行转换。